
Nice design and print, fun keyring and for practical, thinking next time to print with no top layer to show off infill pattern
It's good and works. I have scaled the model down to 59% to fit 4,7cm diameter candles. However the connector pieces are too small. I scaled them up to 64% to give a snug fit.
Dieses Modell habe ich in 2000% Größe gedruckt es ist sehr detailreich für die Größe
I printed this scaled down so that it would print on my Bambu P1s, and used 0.16mm layers. This prints really nicely, with a good deal of detail, it finished in about 2.5hrs
I used cyanoacrylate to attach the engine section to the main body, as the hexagonal mounting key was a little distorted.
Wir benutzen die Pfeife um in einem Projekt Kindern 3D-Druck nahe zu bringen
@THGAMakerSpac_531465 Sehr cool, von solchen Projekten brauchen wir viel mehr.