Easier than I thought

Ezz

Made a little stand for it, looks pretty good

it was a really good print, and when I colored it, it looked very good. I also printed another type of pikachu coin, and this one was better.

Prints without support and infill! Layerheight: 0.14mm

Descripción descriptivamente descriptiva

Printed at 60%, with brim and supports, using eSUN PLA Matte (black) on an Elegoo Neptune 3 Plus. Sliced using Cura and profiles which are not from Elegoo.

The nozzle temp was set to 210C rather than 200C as prints from Elegoo Cura, but the layer height was also reduced from the default 0.2mm to 0.12mm.

Some cleaning up required and perhaps some fine tuning of the print settings would improve my print - but the model itself is superb - 5 stars. Thank you for sharing.