Great file. The smaller one doesn’t have the zip tie holder on both ends. Was that intentional?
View 4 more comments
@JamesHargis_319770 printed 212 of the small one (8 rolls of petg) and my wife thinks i'm a super hero lol. i only wish the pickets were 3 inches taller. i'd modify it if i knew how, but still 10/10 would print again!
@Josephmckendr_407940 piece of cake to make them taller if you want to give it a go, I’m happy to upload a modified version. Only concern would be they might get a little flimsy
Work handed out a bunch of these yetis, and this has been a huge hit. works great.
seems sturdy enough. it might help a bit to have the hoop that goes around the strap part complete so that you can just keep it on the strap.
@JP_304301 thanks for the feedback and good idea! I've added an additional .stl with the closed hoop as suggested.
@Kappa090_278612 I've used the other format a few times now and they work great. I'll print the new ones and give it a shot to let you know how it goes as well as mark it as made. Thank you for the update.
hi, thank you for your great design. printed it and currently using it but the slot for the blower side fan quite loose for me. is there any way you can make it tighter fit so it will hold the side fan firmer? sorry no picture as i'm using my laptop to give review. i printed it in petg using the crush double fan version.
@mis3ry_315344 thanks for the feedback! Yep we can certainly tighten the fit for the part cooling fans, once I’ve uploaded the new version I’ll tag you in another comment so that you can give it a go
@mis3ry_315344 hi again, as per usual this took me longer to get to than I would have liked, however, I have uploaded a new version in the "Version 4.2" folder incorporating the tighter fit for the part cooling fan as requested. I've test fit and it seems really tight to me but if you have the time I would really appreciate if you could print and provide feedback.
Not tested yet