Cool holder i want a door stop bandolier! :)
Tried printing a Medium M and the walls were too thin so just taking it off the bed broke the wall off the bottom. It also wobbles too much and isn't very sturdy even if it hadn't broke. It'll be a decoration in my kids room instead of a box to put things in.
If you can make a version with thicker walls, I'd be happy to retry with an M or O.
Thanks.
@Slicster_1699287 Tried the O with one extra layers on the walls and it worked but then I printed the lid and it doesn't even come close to fitting. (not because of the walls thickness!)
Don't bother with this print. Wasted filament. It will be a decorative letter in my daughters room.
Hi. I just printed the .3mf file. I filled it with coins that are a tiny bit smaller than the bearings you used.
I just want to point out that this cylinder will fit the eSun CARDBOARD spools, but is a mm or 2 too big for the plastic ones. I suspect the plastic spools are older stock, so this may be less of an issue over time.
P.S. The print turned out very nice, screw fits beautifully, and the little internal cap is a nice touch too!
@SeanKonkolics_990942 Thanks for your comment! I tried it in Bambu spools (original and printed) and with Overture cardboard spools. You can modify the size in Fusion 360 if you want
@Josuanbn That's as good an excuse as any to play with Fusion360, as this is something I'd use often.
@faz56710_174696 Thank you for your kind comment:)
Very easy to print. Built in supports helped and were decent to remove.
