Thanks for the model. I increased the perimeters to 6 and the infill to 50% for strength. These printed up nicely and function smoothly. I did find that the 5.1 version of the top fitted better. I may need to enlarge it a bit further. I'm planning to put a set of these together for my son.
@whoeft_1865493 Glad you like it! I also published and recommended a 5.2mm version of the top as well (mine was also a little loose). I ended up adding a dab of superglue to keep it tight. (edited)
@JoshHartmann_303963 Thank you for the new 5.2 top. I will print up some of those and try that out. The nice part is that those are small and quick to reprint. I have also found that there can be minor differences due to printer settings/calibration, as well as differences in tolerances for bearings (and heat inserts) that can also make a difference. I may note when those issues occur, but I try not to register a complaint about a model for that. (edited)
BambuLab PLA Basic
scaled in OrcaSlicer to 75% and reduced the height to 15 mm.
Layer height: 0.2 mm
Wall loops: 3
It's a bit too loose for the tea bag, but the spring mechanism holds it in place.
Thanks for sharing the model! <3 (edited)
Printed in PETG for my Skoda to replace the original cigarette lighter. Prevents there kids from playing around. Also like this sleek design better than the original one which came with the car.
This plug fits perfectly and was well designed. I used PETG as recommended and have absolutely no recommendations that could make this model any better. Thank you!
Thank you for the file! Used the 53mm grooves to make a custom tamper. Sliced it off below the screw portion of the tamper. (edited)
@Starker3 thanks for printing! Is it the diameter that doesn't work or the clearance for the sheer ears?
@JoshHartmann_303963 the breville 54mm portafilter has 3 locking tabs. I created a remix that fits the breville portafilter using your design.
