Nice Fit for the SkipBo Cards.
Easy to print
Will definitely print more for other Games.
Like the snap fit of the lid.
0.2 layer height
Tinmorry sparkly blue PETG
@KarimSurpreme_261916 thanks a lot, I like the effect of the buildplate.
I just uploaded second lid with a stronger snap fit since i experienced that it can get loose while shacking the box.
@Jomstu
I will later give the second lid a try with the next print.
Also works for other Malm furniture apparently. I used it for their side table, where the drawer is missing - thanks for the model!
Printed well without supports and works great (also for Fritz!Box 7510)
My only criticism is that the little pins to attach the Router start printing in mid air. Instead of this unsupported 90 degree overhang that would theoretically need support to print really clean these pins could be made with an angle so they don’t require support. I only noticed this halfway into the print and it still came out ok but I think this could be improved. After a little clean up with some snips it also works well now.
I attached it with double sided tape instead of screws.
@Flondy_679451 thanks for your advise, your use case looks frat. I'm all for support free models and will try to implement it in a next version.
How are you all getting the Side Mount and Top Mount to print so clean? No matter how I place it on the bed, they both will need supports and just makes the result look terrible and rough.
@merlin87_150317 yes, unfortunately both mounts require a little amount of support. I recommend enabling support on build plate and also disable support bridges. If you wish I can also upload a sliced version for your printer. (edited)
