Looks nice but could you please upload STL files?
View one more comment
@Jakob_67_579625 I just made two holes behind each continent and then pulled the LED strip through. So I needed about 2.5 meters.
1
Model: Adjusted original model (see description below) with Denmark addition
Settings: 0.4 nozzle // 0.2 layer // 5% honeycomb infill
Filament: 5144g eSUN PLA+ Cold White
Print time: 199,9 hours
I had problems printing the pieces with their tilted surfaces smoothly enough, so I spent a lot of time and splitted each piece up into its single surfaces. These ~360 surfaces were then printed face down on a PEI plate (yes, missed opportunity, how awesome would it have been with a PEO plate???) and glued together with a lot of superglue.
That was lot more work than I expected, but the final result is more than satisfying! How awesome it looks! Best project ever, thank you so much for your work on the model!
Sadly I cannot share my version of the model with splitted surfaces because of the license, so you would have to do it yourselve ^^‘ (edited)
View 3 more comments
@byWulf hey looks great. Actually the visible layer lines are a design feature of the project 😅 So in general I directly see why you had issues printing it with those settings. You need to use at least the infill I recommend in the description. Otherwise you will not get a smooth finish
@Johannes_8189 Would you consider changing the license to allow remixes? There have been some great modifications shown in these posts, and it would be great if the remixers could share them with the rest of us.
As a Swede, I approve the removal of Denmark.
@Anyplace2789_497449 time to pull out the sticks to hit the swedes again.
@Duckforceone_40842 Good that we have kept up with our ice walking skills ;)
Thank you!