Need to fix the bottom design. Printed with ABS-GF. Everything else came out good but the design at the one end breaks very easy. There’s nothing that supports it to the main structure in multiple areas, makes 75% of the design flimsy. Also, the cap did not fit on the open end and is solid. So, if installed, it will most likely muffle the one speaker. Other than those issues, it would had been a nice design.

I'm not a painter so I don't know how well it works but it seems like a nice functional design. The lid doesn't sit tight but it sits securely and won't slide off. Creality pteg .25mm layer height. Custom emboss for a coworkers daughter.

What infill % did you use? (edited)

I used 30% infill but you can see it hanging my pan on my wall in the shot. The edge of the hole in the bottom of the hand pan sits right on the middle section and the rest is geometry.