What coin are you using? Because what you remixed there is 5 cents, but it certainly won't go into it. You did not indicate this in the description, that it was also changed.
@NandorPok_1374637 I didn’t use a coin, but two washers staked on top of each other. But I’m not too happy with this solution, so I’m planning on updating the model.
In any case, I will update the description with the diameter of the washers.
Love this design!
This is really cool. I printed it as a gift for my mom but I may need to print another for myself. I used silk PLA.
That filament is amazing for this print!
@JasperZwart_1092133 I agree, it came out very nice. I kept seeing a robot face in it, though. lol My mom was very happy to get it, thank you so much for sharing it with us!
Hey, im somewhat confused.
I printed a couple of the B variants, but they dont seem to be vertically
stackable because the overstanding bridges of the cut off honycombs in the top and bottom corner interfer with eachother.
Am i overlooking something here? (edited)
View one more comment
@Jylin_36948 Let me know if this works for you. If not, if you tell me which variant(s) you need exactly I can update that one. (edited)
@JasperZwart_1092133
Hey, i was in need of the
Inner corner 224x190size - variant B.stl
However i ended up cutting them just like you did.
Thank you. The Fusion 360 file was so helpful since my repair was a little larger than your had been. A real time saver.
@davet_140111 Glad to hear it was useful to you, that's exactly why I included the Fusion file!
Printed well. I had to slow the SE down to 80 mm/s. There was too much stringing at 100mm/s. I probably need to calibrate some more
Used Inland tough PLA at 215c/65c
In black PLA - I wanted my corners connected physically, and this worked out great!
@badhex_2078517 Thanks for the comment, so cool to see that this was useful to you!
Thank you for the smaller version - really handy! Now I only need to fill it. 🙂 My only "complaint" would be that the box tips over a bit too easily when opened. However, you made that clear in the description, so I was warned before the print. 😄 (edited)
@R4FKEN Sure, there you go! I added a clean version of the base and the entire trophy. Enjoy!
View 5 more comments
@R4FKEN Yeah I had this on my to do list for a few days, but didn't get to it. I've updated the files, the clean base and trophy are now closed at the bottom
@JasperZwart_1092133 Thanks, I'll make sure to upload a photo of my print(s)!
As soon as I've finished this, I will update with a better looking picture, this one doesn't do it justice...
