Nice, compact design. The chargers both fit great and the cables were easy to fit though the channels for a nice, clean look.
Amazing sturdy design. Just what I needed for my room! The fittings for the magsafe charger and watch charger are REALLY tight and you probably wont be able to get them out without breaking it but it does add a nice aesthetic to the print and I don't plan on taking it out anyways
Only complaint I had was that some phone cases with a protection boarder around the camera lenses wont work with this magsafe print and you will have to take the case off. If the back of you phone case is flat on the back all the way it will work totally fine.
Rotated the print 90 degrees and printed at 0.15mm layer height using Anycubic matte PLA. Supports are needed and I used auto tree supports.
Printed in 3DJake petg white, with thick bottom. Still pretty bright. But better than before.
Fit and work great. I use the lamp behind monitor as backlight and now the light is dim and difused as I wanted. Thanks!
2 layer version printed on Ender 3 with white Aurapol PLA.
