Really easy to print and works great. I'll slowly replace all of the old rings as they break! The inner piece spins freely, so I had no issues with that.
Printed in white PLA+
0.4mm nozzle
0.2mm layer height
5 walls
no supports (small bridge for the square pin)
In your example photo there is a fine hex mesh behind the numbers and center design, but in the file there is just one piece.
Is something missing?
@QuietMike it's done using height range modifiers in Prusa Slicer. The model is a solid piece with different heights for different features, so you can do whatever you like with it using height range modifiers in your slicer. I hope that helps!
@QuietMike the height range modifier setting I use to get the mesh look is zero top and bottom layer for the range you set and honeycomb infill for that range.
Perfect fit and quick print actually holds way better than the original cap (edited)
Quick print with no issues!
I did have to do some experimentation on my end to figure out the right size for the blue EXCEL knives. I ended up printing at 118% and it's a perfect fit.
Printed using a 0.6mm nozzle at 0.4mm layer height. Used floral wire instead of filament to lock in the numbers. Works great!
Nice design, thanks for sharing.
The lid had a really tight fit, so i scaled it up to 205.50mm in X and Y (100.24%) and added some finger grooves using a "negative part" in the slicer.
@etobi_144681 would you mind sharing your modified lid as a remix?
@Forti4040_772712 Sorry. I would, but I don't have a model file. I made the changes directly before printing in Bambu Studio Slicer.
A great simple design. I'll be popping this one straight onto my Honda Jazz keys :) Great design!
Thanks for design!!
Looks great and simple!
Printed with Devil design PETG Rubi Red and white filament
Used ironong on top
@Hobotnica_151189 that looks awesome!!
@AlexVikingo looks awesome!
Es un muy buen modelo pero lamentablemente no contaba con color verde así que lo hice en tricolor (tornasol)
Unfortunately couldn't make it work. I've played around with scale, XY-compensation and flow rate and gave up after 6 tries.
fit perfectly. printed with petg