You need to correct the title this is not for the PSU is for the new buddy board case (edited)
Great box. I printed the 1st one at 100% scale in prusa petg. The length for the nozzle was just about 1mm too short for the nozzle to seat in correctly. Reprinted it scaled to 101% and now they fit perfectly. My old hands had a hard time opening the box without the nozzles flying out so I sanded some of the latch off to make it easier to open.
Thanks! Very handy print. I used this on my BlazeCut for my other enclosure and it fit perfect. I ended up using M3x4 screws.
I also ended up with a weird version of the BlazeCut fire suppression system that I purchased on Amazon. It wasn't long enough to fit my second enclosure where it's supposed to go. So, I made the clip smaller in fusion 360 and pasted it back on to the base so it would fit around the tube and bolted it in a spot that had holes about 180cm apart. (edited)
@VisualReversal Looks good (it's the first tube that i see that is not bended.
Good design. I bit large for my 10yr old, so I slipped on some silicone ear hooks, and silicone nose pads, and works perfectly.
@Lanc3d Glad you liked it. Normaly I heat the ends for example in boiling water or if you want it to bend on a specific place I use an temperature controled airgun (smal tip I use for soldering SMD) about 200 degrees C
Very nice! Thanks for the model! Printed four glasses in one print. Worked very good. I also used a short piece of filament for the joints.
Perfect, love the chicken legs, looks like the chicken want to escape xd
Printed perfect, but takes a support on the bottom
Got a tick on my ankle, because my bike commute makes me go across a forest. Printed that in 5 mn, it removed the tick easily and cleanly, without effort or pain. In fact, the tick was still alive and moving after removal ! Live tick included for scale. This will stay in my outdoor kit. (edited)
Great model and great LED strips. But atrocious instructions and bad pictures. No idea what the cable holder is for. No idea how the model creator managed his cables to tightly.
Had to mirror two "Led bar holder v5 tubehouse bot", so they will actually fit the enclosure. Also "Led bar holder v5 tube bot" and "Led bar holder v5 tube top" will have to be swapped so they stay in place. No clue why the creator named them this way. (edited)
