I used Creality PETG to print this one, mostly because it was what was already installed in the printer.
Feels solid and flexible enough for the purpose, however I have yet to solder anything using it, should be done in a few days.
Since it's base is sort of small, if you put the circuit a little away from the center and apply any sort of pressure, it will topple over, but it should be a matter of properly adjusting the position and know this limitations.
Thanks for sharing the file!
Printed these scaled up to 10.5mm thickness to fit a VIDGA ikea curtain rail, they fit and slide perfectly. Thanks!
@ripkirby_243470 Great to hear, Thanks for the rating! (edited)
Almost as pretty as the original :)
@Sarusani Well its hard to compete with the amazing original but I think I gave it a good shot :).
Never got it working for more than 15 seconds. when I go to the larger diameters, the leaves slip out of the slots and it breaks. now it is just the prettiest thing in my failed prints bin