The fit was just ever so slightly too tight for the box to work, if I were to reprint I would scale the inside piece a bit. Thanks for the model nonetheless.
@brainflakes_2921667 Thanks for the feedback :) I printed this on both my Flashforge A5M and the Bambu A1 Mini and they fit together perfectly, so I wasn't aware that there was an issue with it. If there's any tolerance issue then a very slight scaling adjustment of one of the parts should solve this.
The fit was just ever so slightly too tight for the box to work, if I were to reprint I would scale the inside piece a bit. Thanks for the model nonetheless.
@brainflakes_2921667 I might remix with the scaled model too, so nobody else has to go through the guesswork.
@brainflakes_2921667 Thanks for the feedback :)
I printed this on both my Flashforge A5M and the Bambu A1 Mini and they fit together perfectly, so I wasn't aware that there was an issue with it.
If there's any tolerance issue then a very slight scaling adjustment of one of the parts should solve this.