Gunter 14
Gunter
@Gunter_1709774
published a new model November 23, 2024 at 6:37 PM
November 23, 2024 at 6:37 PM

Quick print and it popped right on.

Ctrl + Enter to send Enter to add a new line
Gunter 14
Gunter
@Gunter_1709774
published a new model November 6, 2024 at 8:29 PM
November 6, 2024 at 8:29 PM

Ctrl + Enter to send Enter to add a new line
Gunter 14
Gunter
@Gunter_1709774
published a new model August 16, 2024 at 9:59 AM
August 16, 2024 at 9:59 AM

Ctrl + Enter to send Enter to add a new line
Gunter 14
Gunter
@Gunter_1709774
published a new model May 18, 2024 at 5:48 PM
May 18, 2024 at 5:48 PM

Trochu nesedi. Skusim vytlacit podla vlastnyxh nastaveni

After rebuilding my Mk3s+ to a 3.9S I get warping a lot more, even on small prints, this supposed to help maybe? Is it good to print this with a high flow nozzle or should I use a none high flow one?

@wckdpotato_484048 I had absolutely no issues printing PLA and Prusament PETG with the CHT nozzle of my Mk4S. This little part should help to reduce warping.

Ctrl + Enter to send Enter to add a new line
Gunter 14
Gunter
@Gunter_1709774
published a new model April 14, 2024 at 2:47 PM
April 14, 2024 at 2:47 PM

Ctrl + Enter to send Enter to add a new line
Gunter 14
Gunter
@Gunter_1709774
published a new model February 11, 2024 at 2:49 PM
February 11, 2024 at 2:49 PM

Ctrl + Enter to send Enter to add a new line
Gunter 14
Gunter
@Gunter_1709774
published a new model February 2, 2024 at 9:12 PM
February 2, 2024 at 9:12 PM

Just had to mirror the parts to fit my reels orientation, but perfect design for my usage :) (edited)

Very nice design!
Thank you!!

I have a problem with it and maybe you can help me: I tried using the following parameters:
- 9mm tapewidth
- 0.5mm tapethickness
- 1.3mm tapedepth
-> this should be within the limits!
But once I set tapethickness to something below 0.8, the model behaves "strange".
It's really hard to explain, so I attached a picture.
As long as tapethickness is >= 0.8 everything works.

Is there a workaround to deal with that?
Do you have any recommendation?

Thank you for the great design and especially for publishing the source files too :)

View 2 more comments

@Gunter_1709774 Thank you for the super quick help & reply!
I'm going to test this tomorrow - thank you!

@Gunter_1709774 Perfect - it worked!
Thank you :))

Have a nice evening!

Ctrl + Enter to send Enter to add a new line
Gunter 14
Gunter
@Gunter_1709774
published a new model February 2, 2024 at 8:07 PM
February 2, 2024 at 8:07 PM

Ctrl + Enter to send Enter to add a new line
All items loaded