This is great, thanks for making and sharing this remix!
The original was the first model I created/shared and I hadn't learned the art of using heat-set inserts at that point. I had intended to go back and add another version for inserts but never got around to it.
@BalintPal_644600 As the instructions say, print that cylindrical part in case you have an issue with screwing the nut through the screw post. It's a removable guide.
For the second nut, that's to add a second nut incase the card is so heavy that it pushes too much and the filament is shinney and the nut slips. The second nut acts as a stop if the first one tends to slip and turn itself. (edited)
Really funny Coaster, I am new to the printing Community and the model turned out really fine. Had a little problem with the feet, but this is down to my settings on the printer i think. Will print some more soon ^^
@LK_298891 Yeeeh, as it is right now it needs supports at the feet section. Should have made it more carefully as to not need any, but i just wanted it out XD