good games 3d model

Exactly what I needed for my 1991 YJ, thank you for saving me the trouble of having to model one up as well. printed in ABS
Does what we need it to. I affixed it to a tile with 2 sided tape. Only issue is our wand turned in holder. I fixed that with remix https://www.printables.com/model/658930-shower-wand-holder.
@CharlesCanni_1112654 I actually had the same problem with it turning, I put a stick on rubber piece in the back of mine, otherwise its been holding up for about a year now with no issues
Did you need supports to print this? How was it set up on your bed?
@Ian_837890 i printed it vertically, with the supports on the inside of the lens, and for the tabs on the sides.
when its done, there should be a gap between the supports and the lens where you can fit a flathead screwdriver, and pop out the supports.
i printed mine in transparent PETG and they've held up perfect.
@GQinc perfect! Thank you. One of my lenses is pretty beat up and this will work perfect for me
Had to print 4 times before I found the right orientation to print without the nubs breaking off. Personally printed in white petg with a 0.2mm nozzle and the result is very nice. (edited)
My girlfriend loves it! she lost her last one.
Ignore the fact that i am having bed issues, this printed fast and dirty, works well and does the job (see other makes for how pretty it can be)
@Pigeon_Soup_2333814 it prints better if you print it vertically, so the side is on the buildplate, ;)