Printed great and im sure it would fit well, but it appears I do not have the Diaper Genie "Complete" so the lid is slightly different.
If anyone finds a print for the regular version let me know!
I hope you are submitting this to the contest. Because I was just about to make a replacement lid for my broken diaper genie.
@Cryptik_One_1254873, good timing on my part : ). I did submit it, yes. This was one of the backlog projects I had planned well before I'd even gotten my printer up and running. The contest and theme was lucky timing.
If yours is compatible and you end up printing it, let me know how it goes!
Confirming what another user mentioned that the case uses M4 screws. #6-32 was a very loose fit that will likely strip out.
Otherwise awesome model–thanks for sharing!
Passt perfekt! <3 Jetzt noch ein bisschen Kabel Management ;)
Fits perfectly! <3 Now a bit of cable management ;)
@Doco_1169356 Thank you :)
@Doco_1169356 I used M4 screw after using a thread checker to check the screws that came with my case. I tried a 6-32 and did a lift test with my hands and it pulled out violently.