that a cool jeep body i like the details that you put in it! by the way what program did you use to design that model?
@chris_2525597 Fusion360
Printed out wonderfully as a mostly-single-piece; I sliced the roof off to save on support material. There's still some work to go, some sanding to do on the hood which shows the worst of the layer lines, and final fittings on the truck, but it's looking promising! Thanks for the model!
Did you ever upload the bearing-less version of the files? I cannot find them on your profile and would like to try out an all-plastic version for a first test before committing to the cost of a slew of bearings. Thank you!
@WubsyWibbles I too would like to do the same.
how do you get wheels
Turned out really well, great design! What hardware does every one use to attach stock wheels to?
@NathanC_2460094 the hex piece is there to go into the stock wheels. you put a screw through the back of the axle holes. does the pic make sense?
@ExPigeons Sweet, thank you, I was wondering what that was for!
i'm about to print it for a lizard that i made
What size is it at 100%?
Do you have smth like based on Trijicon Pistol sight ( https://gritroutdoors.com/optics/sights/pistol-sights/ those) ?
A seriously fantastic set of iron sights that is one of the best modelling I have ever seen. I remixed for lower FPS usage on foam blasters with a shorter front sight and added adjustability to the sights. Thank you for sharing. These are the best sights ever.
@distinctIndus_353413 Do you have the remix uploaded somewhere because I'd love to have it work with lower FPS.
Very nice. Thank you for sharing this model. Any chance you will share the updated CAD file?
Here is the label I made for it: https://www.printables.com/model/1201799-gunpla-toolbox-efsf-sign (edited)
Best to print it in the orientation that it comes in? or more like a 45 degree angle?
View 2 more comments
@Beneto_119102 ok so the skull has a flat part at the back of the head. that should be on the plate. the jaw also has a flat you want that on the plate as well. the neck piece has a picatinny rail through it. when i printed it i made sure that cutout is parallel to the bed. Are you using fdm or resin?
@ExPigeons FDM. Pretty sure that’s how I laid it all out as well.
Nice looking magwell for standard NERF full-length magazines. Reloading feels easier with a general guide, however the tolerances are slightly off as the upper part isn't a flush fit (I can physically squeeze it), and it does not have a smooth entry like a flared magwell. Still, a great model, and fits securely with zero rattle.
Printed with the generic filament that came with my SOVOL SV06 printer.
more darts = more better
thanks!
(PLA and ASA)
Looking forward to putting this to the test :D
@ExPigeons As for now, has it ever failed or broken somewhere? I saw damage to thin walls on some other 8 rounds design like this, so I was wondering; if not, great work mate! Also if you have suggestions to make it more resilient is some critical points, like longer rings or maybe two separate pieces (an inner crown and an outer crown), or ideas like these... However, I was searching some files like this so great job.
@TomMcHawk_2565623 so far no but i print in petg so that might be why
can you make a version for nerf rival?
pretty good, it was a little hard to get the mags in without cracking it. would recommend printing at 103% to have grip on the mags but not break.
