Impression en PETG
Modèle à modifier car le système de mouvement entre la pince et la poignée est composée de plaques à coller pas bien pratique.
Mais le projet est sympa 👍
What approx strength have you tested this for so far? I can pinch about 120lb on one hand and hang about 150lb on one hand on 15mm. I assume this would need to be able to endure 2x that?
@Edition5956_971163 I confess I haven't tested it 😬, but it wouldn't be easy to give you an answer as it varies according to the direction of the print, the filling, the plastic used, etc ... I've mainly adapted the game so that it's printable, to support the players' recovery of strength and improve the grip to prevent the hands from slipping, since with plastic it would have been harder to hold on.
PS: Personally, I'd have printed the top piece on one of its sides, putting the layers in the direction the players will pull, slightly increasing the filling see the walls compared to basic prints. With these characteristics😅, you'd really have to go out of your way to damage it, I think. Just in case, I'm going to run a simulation this weekend. If it helps 👌
to get most strength print on side and with something like 5+ perimeters at least. very high infill won't help much here
nice work! really liking it.. are you able to knock something up for the XOL toolhead barf faceplate? like stand off over the fan hole? ive tried but im no good haha
