I’m back with another question after buying a used ratrig. Will this printhead work with a stock vcore 3 rather than a 3.1? I’m thinking the belt paths might be misaligned
@Auggie_53804 Not sure, I don't own one. I think it is mounted with two screws? Maybe you can add two holes to the underside of the back-bottom part inside the slicer and mount it there?
I’m back with another question after buying a used ratrig. Will this printhead work with a stock vcore 3 rather than a 3.1? I’m thinking the belt paths might be misaligned
@JamieClarke_466858 Sorry don't know, never had a 3.0.
Is it possible to integrate beacon sensor to this setup?
@Auggie_53804 Not sure, I don't own one. I think it is mounted with two screws? Maybe you can add two holes to the underside of the back-bottom part inside the slicer and mount it there?