Has anyone tried printing the clamp on it's side to increase the strength? Printed this for a campout this weekend and we started using it and it worked until someone tightened the screw just a little too tight and it caused it to split along a layer line.
Updated my snap-on can lid with sliding cover to version 2.0
Improvements include - overhanging fillets to chamfers for better printing - wider mouth opening 90->120 degrees - adjusted slot to accommodate - new font
Orca gives the following error message on the passthrough There are warnings after slicing models: The object has empty layers between 117 and 117.4 and can’t be printed.