Got tired of my tape gun being in the cabinet and this fits my HSW perfectly! Thank you!
Ran the model off in some spare filament I had that was low. Ssds fit a bit tight but not too bad and the connector fits pretty good. Might adjust the bays to be a hair larger in both directions
Ive had mine on the while for a while and im constantly backing my chair into it. Can confirm it holds on the wall surprisingly well. Thanks for the Review
Doesn't fit well at all. The weight of the set makes it wall off the hsw. Not recommended!
@VincentKiwi_30472 Im sorry this doesnt work well for you. Mine does fit pretty well but my wall was printed on some older printers and may have bad tolerances. However this was the second make of the one peg model and it doesn't seem like its working well for others. Im going to pull that file and leave the 3 peg model that should be better for everyone. Again sorry for the issues hopefully you are are to fidn some other use for it
Used to check a fix to my AMS (retraction failure issue). Took 11 hours 30 minutes to print, with a lot of filament swaps.
A lot of wasted material from this.
@boggisthecat_296022 Yea I knew it would waste a ton of filament. Originally I was going to run in a much larger scale to have as a desk model but never got around to it. Ill add a comment about filament use when I have time to warn people.
@Doombeast13_659433 Hi. It wasn't a complaint, as I wanted something to stress-test the filament change and this does the job.
People should be aware that you get the same amount of waste from printing one item or multiples of the same item - so if you wanted to print a dozen of these then it wouldn't be too bad.
Your painting skills are good, by the way. I gave up on an attempt at lettering and figured out a way to split the model instead.
My first multi color print to test my AMS. The waste is definitely a problem, but that isn't a fault of the model - it's how Bambu handles filament swaps. But it came out great and was a perfect torture test. Thanks!
I'm in the unfortunate middle ground where the larger hangar fits my mallet but doesn't fit in the HSW well and the smaller mk2 fits the wall well but it a bit too small for my mallet. The fit of the mallet is my issue, obviously. It has a 60-63mm diameter. (edited)
Very great design but Are these backwards? I Printed the left one and it puts the DMB logo to the back side, which is hard to see. Would think it would be on the front. Also did you have any issues with the letters breaking off? The letter are not imbedded into the book end much at all, would you possibly be able to imbed them a little more? Thanks so much!