5/5 for the idea - brilliant.
However the models needs more modelling. The batteries cannot click into the holder. It's too tight of a fit.
The single holder with extender doesn't sit on the print bed when downloading.
The holes for combining the no. 1 and no. 2 are not at the same heights, so you cannot combine them without cutting the pin.
The pins are too big when printing and does not fit.
Print looks very clean and the idea is good.
But again, it needs some more love.
Thanks for the files anyways!
Nice and quick print, not much else to say about it, simple and easy.
Printed in Sunlu metaPLA grey at 0.2mm layers.
im glad it could help even dough its not hard to make.