Is there a trick with the magnets? I tried making this, but the magnets can't even hold up the weight of the 3-d printed part... I feel like i am doing something wrong.
I even tried adding 2 more slots for 2 more magnets, but it was still weak...
I feel like I am doing something dumb here. Do your magnets all have the same polarity when inserted?
I was looking for new projects and saw this. I printed the parts with little effort. I have a chain with magnet, but the hook needs to be placed into the lock hook. I'm always afraid it will be left in it. Slam the door as it take a bit to close these doors, and break the washer. Thank you for the model.
@aszajlai Thank you for the Make and the 5 star rating. Much appreciated. Enjoy!
I needed another way to get the filament into my printer case. I saw this while looking for a different item to print. I was able to download, and slice followed by printing. I just need to see where I want to mount the item under the top of the lid. I did notice that it has hex spots instead of just screw holes. Can you comment about how you connected to the bottom of the lid? Thank you for the model.
@aszajlai the hex is for anyone that may be mounting on a thin enclosure such as metal. I used it in my IKEA Lack table enclosure that I built. Therefore I simply used short wood screws for mounting the guide to the underside of top of the enclosure. (edited)
It is printed with Azurefilm PETG UNSET. Printed correctly, unfortunately, the model doesn't complain about some 3D printing principles and breaks apart in a few places. I understand that is a compilation and mostly all remarks go to the original one, but steel
View one more comment
@CupertinoGeek_578063 First it is printed like you suggest in your info page of model. Also like I said you just use other model and create multiple version of same, so like I said in my comment it isn't up to you mostly, but fixing some issues will benefit when you remix. One of factor may be that my PTEF tube is stiffer so the existing 1.32 mm wall printed vertically is not enough to hold 1mm tick wall of PTFE tube. Just to add with that type of filament and the same settings I achieve a very strong 3D prints. (edited)
@DubravkoPenezic looking at your photos it is obvious that there are issues with layer separation. Good luck.
@Andreas_393935 Thank you for the 5 star rating!!
my ffad5mpro isn't great for resolution, but after some cleanup with my exacto knife & my dremil i now have a handy tool for lubricating those pesky bearing for the linear rods on my e3ng. much appreciated! 😁
