Printed in black TPU, very slowly with supports
Hey, thanks for this great design! I was wondering if you could upload a version with just one side, or perhaps separate files for the left and right sides? That would be really helpful. Thanks in advance! (edited)
@wolpa_3020410 Hey, you can cut it in slicer and remove any side. I added what you asked for. (edited)
@Corsair1303_2721219 Thank you very much!
I'm glad you like it. For TPU I design this one: https://www.printables.com/model/1154860-geprc-phisital-mark5-bzgnss-bz-181-gps-mount-tpu
Works for me. It is a bit too narrow which makes the brush clamp some times which makes it hard to remove. Also I just need one brush as the others can be removed only when removing the ones before. Printed in Prusament PLA orange
@IamJoe You obviously have a different size brush. My pieces fit with a clearance of 1mm. I added a file with clamping for one brush (space for brush is 11mm, if it's still not enough, let me know, I will make bigger one). (edited)
I use it to put my scissors on the rail system. Works 100%. Great fit. Not too loose or too tight. Printed in Prusament PLA orange
