Imprimé en PETG
J'ai déjà utilisé plusieurs protections, et celle-ci est top
Merci
@Domthebomb_1931658 Love the color combo! Looks so cool. That does look similar to Mario Dittrich's description of the fit issues with the bottom trigger mount gap.
Tolerances are TIGHT. Printed in PLA, quality mode (.12 layer height), the trigger guard almost didn't fit. Had to use zip ties to hold it in place while I screwed in.
It has a slight crack already in the lower guard, that can be re-printed, again, I think it's because it has no give. Which is perfect, it doesn't move, just need to be considerate when installing!
View one more comment
@ChubbyEwok_836013 If I re-print the lower, I'll try with the ziptie first, I tried about 40 times to hold and screw in with just my hands, so it kept getting pulled left/right anyway. It's not helpful (not on you) that the height on the M3 nuts are also super tiny, so getting them juuuuuust right is the worst haha.
My neighbors already love the gun, we're going to get some use out of it at a block party this weekend!
@JustinAche_2169418 Sounds good! I also did print mine all in PETG which seems to be a bit more tough, which could be why I wasn't getting any cracking/failures when designing originally.
Glad you all enjoy the model!
