Commemorative gift for friend.

material: PLA
nozzle: 0,4
layer: 0,15

material: Plasty Mladeč PETG
layer: 0,1 for perfect thread
scale: X,Y 101% for clearance in thread

Petg, 0,6 ,Fast print . Vnější závit sedí perfektně, vnitřní mi moc nešel s kohoutem dohromady chtělo by to trochu větší průměr. Ale jinak dobrý.diky

material: PETG-S
nozzle: 0,4
layer: 0,2

It is necessary to seal with teflon tape.

material: PLA ( + chrome spray )
layer: 0,2
nozzle: 0,4

material: PA6 CF
layer: 0,15
nozzle: 0,4

Function, nice. I need ESD material, then I used material with carbon.

size: M10
mat: PolyMide PA6-CF
layer: 0,2

I used nylon for greater strength of the hook.

mat: Fillamentum Nylon CF15 Carbon
layer: 0,2
nozzle: 0,6

Interesting solution. It is worth noting that the “higher” level is half a block higher. Probably worth printing two + half a block to make a U-turn. Thank you for your project :)

Function testet - OK

Fit perfectly.

Raft: yes
Support: yes
Resolution: 0.05 mm
Infill: 100%
material: tough resin (edited)

It doesn't fit perfectly, it's a little big.

Raft: yes
Support: yes
Resolution: 0.2 mm
Infill: 20 %
material: PolyMide PA6-CF

material: PETG
layer: 0,2 mm
support: yes

mat: CPE
layer: 0,2
support: yes

printer: SL1
suport: yes (edited)