Idea looks amazing! Only improvement I'd like to add - clip for additional mechanical fix, so it can be used in moving connections

a sliding cap with a clip to lock the connectors would be a nice added feature so the wires don't slip out of the stack when plugging in or out. Also, reducing the connector sleeve's height to 12 mm to allow for side PCB connections would be great. I sliced it in prusa slicer to reduce the height of the connector. (edited)

Very cool print.

Love a good pop art 😁

Sorry for correcting, but this is a JST XH2.54 connector, not a JST 1.25 that you've mentioned your post.

Now testing phrase, came out quite good

I like the design. The left screw mounting hole is very flimsy though, it broke off once so I had to reprint it

Cool Design to organize my m1 mifare writable NFC-cards!

I added a block under the spring to hold enough tension for my 20 cards.

Assembly was a bit fiddly, but after that it works as intended! Thanks!

cool idea! i will print it

Reduced the height to 100mm but only for space concernes, it printed great and the lids fit perfectly. Thank you for the desing!

Thank you for this. I was worried about the lids not holding tight but they fit great.

I think this is the tallest print I've done. (edited)

Nice Idea, but could you also upload your second model that you use for the acoustic guitar (the longer ones)? I don't want to simply scale the whole model, because then the inner parts would get messed up (edited)

Came out great, and love that it moves along with the Z axis. created a remix that adds a 30mm spacer to put the camera right above the print bed when at z axis 0.

Thanks! Very useful!