Does a great job thus far. Supports were very difficult but it holds up just fine as it is. I just wish I could get it to look better. Tree supports were a nightmare.
This doesn't print right. It ends up being broken layerseven with supports.
I added a ring to make it an ornament. I couldn't do a color change without leaving some gold in the corners. It would be awesome if you fixed that.
How much should this be scaled up? the stl is only about 12mm tiny...
View one more comment
@JoshHartman_1055350 please let me know!
@ChristoB_547826 Sorry for the late update but scaling the model to 1000% in Cura worked. The bottom of the stand is a little small which can make using it with any other playmates ship difficult but the top of the stand is the right size. Those two top protrusions seem to be made to pop off for some reason but I was able to get my Romulan Bird of Prey balanced on top without them. They might work better with the Voyager model but I haven't tried it.
This is awesome! It's great when fans care about such attention to detail. I'm going to adjust my split combadge model to match your more accurate dimensions.
Thank you soo much for all your time that went into this model! I made a few but couldn't decide how I would like to wear or mount it, so I did all the ways I could think of!
Magnetic strip, tie tacks, and Velcro.
A beautiful looking prop that I'm going to give to a friend who really loves Star Trek!
Resin printed on my GKTWO.