Thanks for the model, printed in petg-cf
As mentioned, this version of the rivet holds 1.25 mm thicker plates than the original that was made to hold the thinner original acrylic glass plates. If you just use them to close the hole, this version should work as well. (edited)
@Canislupus maybe I'm doing something wrong, but they look the same when I load them side by side in PS
Nice. Fits good to my "Bauhaus" box.
I think abot gluing the handle that it can not drop out. Printed in PLA with 0.24mm layer height.
Printed in pla, friction fit and wont budge without persuasion
I retract this statement. I have bought a new lot of euroboxes that apparently have bigger openings. (edited)
Nice desing with material saving in comparison with other models, but falling out.. I would recommend to add some "bumps" like on the 2nd picture (different model here on Printables)
Model was very easy to adjust to my needs. Because we have the same Happybrush I just added some names.
Printed the whole thing with Redline Wood-PLA which came out very smooth. After a little sanding we put on some wood protection oil which should help to make the whole thing even more water resistant and also gave it a nice color finish.
Thank you for the great design, sir! (edited)
Nice to see, that you managed to apply my remix approaches. Thanks for the feedback. BTW - I like the color you chose!
Great model! I like that it screws in place and there is no danger of it coming apart! Still looking for filament refills that will fit on it.
can I ask for the adjustment of the central part "prusa-thread" to a height of 57mm? Thank you
Perfect, I also needed it for my 6x dry box