What's the deal with the internal geometry not being consistent? Seems like one side is not as tall which ends up slicing super oddly.Sliced in V2.0.0 Orca Slicer. I even tried the "Fix Model" option and "Simplify Model" but neither could fix the problems with it.
@rulevoid_1653630 i can watch to it and maybe you could try a other slicer like i used cura and it printed without problems (edited)
@rulevoid_1653630 i did fix it so now it should be good
Snadný tisk
What's the deal with the internal geometry not being consistent? Seems like one side is not as tall which ends up slicing super oddly.
Sliced in V2.0.0 Orca Slicer. I even tried the "Fix Model" option and "Simplify Model" but neither could fix the problems with it.
@rulevoid_1653630 i can watch to it and maybe you could try a other slicer like i used cura and it printed without problems (edited)
@rulevoid_1653630 i did fix it so now it should be good
Snadný tisk