Nate Wismer
@NATEwismer_716891
I'm printing this now to give it a shot, I hate my cable chain that I have now it keeps falling off every once in awhile and coming out. You did a good job at this it looks amazing I hope it works, i'll make a few tweaks if I have to as well
@MX699_356461 thx bro good luck and let me know if you run into any issues with it/come up with any solutions aha would rly appreciate it! Seems to be running pretty well on mine other than some snagging issues on the right side
Phew! Tough crowd in here. 😳
Absolute game changer for isolating the printer and what it stands on5with the added benefit of more clearance beneath the printer for cleaning and cables), best option after putting the printer on the floor. Definitely cannot print at lower infill settings that what is mentioned (edited)
Printed one leg with 2 different settings to test. One with 3 walls and 15% gyroid infill. One with 2 walls and 10% gyroid infill. Both with Overture TPU. The one with 10% and 2 walls seems to have the best flexibility of course but is still stable, so i printed 3 more to match. It does seem to make a difference in sound with the wooden end table I have my printer set up on. Previously there was a lot of sound that the table seemed to amplify. No noticeable change in quality for me. Thanks for the files.
@Dale_1750592 You're the man for saving me from some trail and error. I'm going to whip up a batch @ 10%!
Printed in Grass Green Overture High Speed TPU without a problem. Does seem to cut the vibration noise down and have noticeably seen my shelving unit shake less while printing.
Turned out great, even at .2mm layer height (was impatient). Gonna be a great gag gift for a friend!
