Prints very well and is wonderful to play with! Thanks for this nice model!
Printed in translucent PETG since that's what I had already loaded, should make cleaning my frog tank a little bit less messy! Thanks!
@kellyjprice_1320887 thank you for the review.
The thread fitting was good?
@Ben_248894 yup, no problems there.
I printed these in two colors to show polarity, plus some endcaps. It's a great design, and I appreciate all the options. I used the 6x2 option since I had a ton of those magnets on-hand. The hold isn't quite as strong as I'd like, but I know that would probably be the case going in. Thanks for sharing!
@Aaron thank you for the review.
I did not made the holes for the magnets to tight, because some have the problem to get the magnets into it.
You can use some super glue.
@Ben_248894 Oh, I didn't mean in that way. Just that 6x2 magnets aren't the strongest magnets out there (which I knew going in). I did use glue and I have no issues with the magnets coming out.
@KiloxTango thank you.
Excellent print. No more handfuls of loose bobbins for travel stitching anymore.
I love this. but can you do them for the double wide drawers?
Double wide drawers would be amazing!