What are they attatched to in the first picture?
I have some parts left over from my tornado bow would a 9562K45 work in place of the printed seal?
@BobletLoglet_2623094 oops forgot to check nerf haven, you need a 9562K46
Is there an easier to find pvc size than thin-wall 1 1/2 in for a rainbow pump that I can find at a hardware store?
Friction fit real good. Love seeing mods for less used blasters. If you make more for this one please lmk
Is there a lot of friction between the PTFE Tube and the Spool? Does the ptfe wear down?
There's not very much friction with plastic spools, and so you can put some fittings into the box and feed filament directly. If you have cardboard spools, there's more friction, and it doesn't work as well. The PTFE hasn't worn down for me. (edited)
Turned out good, did have to scale to 95% to fit on a mk3. Magnets fit but were tight.
Hello! Thanks for the awesome file! I made this board but changed it so I could print it on my Ender 3 pro! (edited)
I printed these in TPU and they came out wonderfully. I also changed the infill to hex to show off the pattern since the yellow was a bit transparent
