Baal Zebub 11
Baal Zebub
@BaalZebub_240318
published a new model June 13, 2022 at 9:39 AM
June 13, 2022 at 9:39 AM

Ctrl + Enter to send Enter to add a new line
Baal Zebub 11
Baal Zebub
@BaalZebub_240318
published a new model June 9, 2022 at 10:27 AM
June 9, 2022 at 10:27 AM

Ctrl + Enter to send Enter to add a new line
Baal Zebub 11
Baal Zebub
@BaalZebub_240318
published a new model June 9, 2022 at 10:25 AM
June 9, 2022 at 10:25 AM

Idea is good, but actual solution not that much... The holes were bit too small and also the labels aren't visible from back of the drills.

@Ande Thanks for the reply, tested it on a couple of other printers, and i see your point. In my next rendition i will make the holes a bit bigger so it shouldnt be a problem. i have put a bit of paint in the labels to see if that makes it better, but think i will put the labels in front insted. Again thank you for the feedback :)

Ctrl + Enter to send Enter to add a new line
Baal Zebub 11
Baal Zebub
@BaalZebub_240318
published a new model June 9, 2022 at 10:12 AM
June 9, 2022 at 10:12 AM

Ctrl + Enter to send Enter to add a new line
Baal Zebub 11
Baal Zebub
@BaalZebub_240318
published a new model June 9, 2022 at 10:09 AM
June 9, 2022 at 10:09 AM

Nice and simple! I was a bit sceptical, but it actually works well for spatulas with handle too.

Ctrl + Enter to send Enter to add a new line
All items loaded