This really looks great! Any chance you could increase the height to 1.5 inches?
@BigDizz_2812986 could probably do that in your slicer
Printed in PETG to test-fit and see how it hold up to higher chamber temperatures since it doesn’t have much force on it.
I cut the bottom 3.969mm off all the models and printed them separately then glued them back on. This ensured all the parts were maximally flat and removed a lot of supports.
The glass fits tighter to the riser than the riser does to the printer. If I were to print it again I would probably scale it up by 0.2% on the X and Y axis.
Great model, thanks.
