Printed this in vase mode for my daughter. She really likes it.
@StevenTh what temp does the base and the top need to be at?
@vincevojik_2774727 I've printed in Prusament PETG with all layers at 240°C. Bed temp was set at 85°C
Very nice design. But i have had some problems with the batteries getting stuck
Great design. It holds a ton of batteries and seems very stable. We'll see if it continues while I use it but the first AA I took out of it left the rest of the batteries jammed and I had to poke and prod to get them to fall down. May have just happened to fill it the right way to jam it so not sure. Still a great design.
A make of the short version
Revo Six 0.4 @ 0.20mm Structural
Filament used:
Prusament PETG Orange
Nice design
Thank you for sharing!
I printed a version "without extra battery", unfortunately there is not enough space at the wall to unlock the clip when you want to remove the radio. I had to cut a piece above the clip hole.
Other than that very cool design, the radio fits in the holder.
Very useful and almost perfect. With a hole in the bottom to allow USB-C recharging would be very very perfect.. :-) (edited)
Amazing model