Very nice an clean print in Vase-Mode. Works well with the tealight.
My little Snowman likes it (a lot) ;)
Thanks for the design.
Hey! Im trying to slice the vase mode version in Cura but it's giving me a solid bottom layer and lines inside the "vase" as nozzle is moving from star to star on the opposite side. Any ideas why this is happening?
View one more comment
@romanzh_392152 This is happening to me right now and I'm trying to figure out how others, using Cura are getting the hole in the bottom with out it being solid like you mentionied. Also I see the lines inside when slicing in vase mode.
Did you ever figure it out? I'm trying every thing I can think of in the setting that might do this but no solution yet.
@romanzh_392152 I figured it out and wanted to pass this along, in cura under Mesh Fixes make sure you uncheck the box that says: Remove All Holes
0.2mm vase mode, I had better results in vase mode than normal, the normal print had lots of lines and a few holes throughout 😔 I am only just starting with prusaslicer though😏
Generic cheap pla.
Works well on a multicolour led base I think.
Thanks for sharing 👍
Allmost the same dimensions for the remote of my auna soundbar. Still used the model with m3 holes, but finally used it with tape.
