AlexTrebs 4
AlexTrebs
@AlexTrebs_480251
published a new model February 13, 2023 at 8:29 PM
February 13, 2023 at 8:29 PM

Great snug fit. The only pitty is that logo is upside down but thats the problem with Anker, not the model.

Pretty good design overall. I would like to remake someday and raise the disc slightly higher. A lot of the cables I have are not able to bend enough to be used on the bottom. You need to buy or make feet to raise it up for most cables. Probably one of the best models I have seen for this type of setup with the Anker pad. Well done!

I printed in PETG with a 0.6mm nozzle and .2mm layer height, 40% infill. I used paint on supports in Prusa to support the big bridge at the bottom. Cura supports would keep getting knocked off and it would sag too much without supports. (edited)

Ctrl + Enter to send Enter to add a new line
AlexTrebs 4
AlexTrebs
@AlexTrebs_480251
published a new model February 12, 2023 at 1:01 AM
February 12, 2023 at 1:01 AM

Ctrl + Enter to send Enter to add a new line
All items loaded