Is it possible to use these plates on the K1? There are none in the file list for the K1/K1C Remix aside from the chain guard plates and these seem like the same height but I’m not so sure about the length. (edited)
@Yodog_229737 I will get to this eventually I'm just very busy with work and life. I designed this while I was on vacation but do plan to eventually make a version without the slider.
Is it possible to use these plates on the K1? There are none in the file list for the K1/K1C Remix aside from the chain guard plates and these seem like the same height but I’m not so sure about the length. (edited)
I'm starting to print the parts, but please, could you make a version without the glass slider? Thank you so much!
@Yodog_229737 I will get to this eventually I'm just very busy with work and life. I designed this while I was on vacation but do plan to eventually make a version without the slider.
@AP_1324896 any chance of you updating this?