I just wanted to let anyone know who may be printing a print-in-place version of one of my swords or lightsabers with default profiles in Prusaslicer that its probably not going to work if the "minimum travel after retraction" setting is greater than .4mm. This will cause your printer not to retract at layer seams since the segments are all concentric. The default profiles for the XL, MK4, and the Core One are all set higher than this, so you will have to change it for it to work properly.
I just wanted to let anyone know who may be printing a print-in-place version of one of my swords or lightsabers with default profiles in Prusaslicer that its probably not going to work if the "minimum travel after retraction" setting is greater than .4mm. This will cause your printer not to retract at layer seams since the segments are all concentric. The default profiles for the XL, MK4, and the Core One are all set higher than this, so you will have to change it for it to work properly.